Bionaire BAP1500 Manuel d'utilisateur télécharger pdf (Page 3)

PLEASE READ AND SAVE THESE

IMPORTANT INSTRUCTIONS.

With proper care and use, this Bionaire

air purifier will give you fresh, clean air

for many years.

NOTE: Before reading these instructions, please

view the corresponding illustrations.

DESCRIPTIONS (SEE FIG.1)

A.Power Light

B.Speed Control

C.Oscillation Button

D.Ioniser Control

E.Filter Indicator Light

F. Ioniser Light

G.Washable Foam Pre-filter

H.Inlet Grill

I. PERMAtech™ Filters (2 pcs)

J. Filtered Air Outlet

SAFETY PRECAUTION

Carefully read and retain all instructions before

using the air purifier.

•To avoid fire or shock hazard, check that the

voltage on the product corresponds to your

electricity supply and plug directly into an

electrical outlet.

• Keep cord out of heavy traffic areas and to

avoid fire hazard, never put the cord under

rugs, or near any heat source.

• Carefully discard any plastic wrapping that

was used for the packaging. If the filter is

covered by a bag when shipped, remove

plastic bag before use.

• Do not use the air purifier outside.

• Do not place the unit near any heat source or

in direct sunlight.

• Always unplug the air purifier before moving it,

opening the grill, changing the filters, cleaning

the air purifier or whenever it is not in use.

• Do not use in or around water or any other

liquids. Do not attempt to wash the unit under

running water.

• Use appliance only for intended household

use as described in this manual.

• Ensure that all air openings are not restricted

or covered in any way.

• Do not place anything on top of the unit.

• Never insert any object into any openings.

• Do not use the air purifier if any part is

missing or damaged in any way.

• Do not attempt to repair or adjust any

mechanical functions of this unit. If the unit

becomes damaged return to the place of

purchase or phone the helpline number on

the back of this leaflet.

• If the supply cord or plug is damaged, it must

be replaced by the manufacturer or its service

agent or a similarly qualified person in order

to avoid hazard.

• The air purifier contains no user serviceable

parts and should the product suffer damage

or breakdown it must be returned to the

manufacturer or its service agent.

• Should the air purifier stop working, first check the

fuse in the plug (UK only) or fuse/circuit breaker at

the distribution board is operating, before

contacting the manufacturer or service agent.

• The ioniser may cause a static charge to build up

on the air output grill. A static charge may be felt if

the unit is not properly grounded. To avoid a static

charge, plug the unit into a grounded outlet, or

properly install a ground adaptor. The static shock

will not occur if the ioniser is off.

• Close supervision is necessary when any

appliance is used by or near children, or

disabled persons.

HOW THE AIR PURIFIER WORKS

Dirty, dust laden air is drawn through the back of

the air purifier and through the multi-stage

filtration system.

1. The carbon filter will help clear odours making

the air cleaner and fresher.

2. The PERMAtech™ filter entraps 99% of all

smaller visible and non-visible particles down

to 2 microns in size.

IONISER

Your Bionaire

Air Purifier has an independently

controlled ioniser, which when turned on,

releases negative ions into the outgoing filtered

air. Ions are tiny particles that carry either a

positive or negative charge. These ions exist

naturally all around us in the air, water and

ground. Both positive and negative ions are

colourless, odourless and completely harmless.

Negative ions help the air purification process

by attaching themselves to very small airborne

particles in the room. These particles take on a

negative charge and may join with positively

charged particles, such as dust, pollen, smoke

and pet dander to form larger particles that are

then more readily captured by the filter system,

or they may be attracted to positively charged

surfaces like walls or floors.

You may also note, after extended use, that dust

may have collected around the grills or front panel.

This is from the ionisation effect caused by the

negative ions exiting from the air outlet.This dust

does not come from the air output, but Is drawn out

U.K. and IRELAND

of the uncleaned air going past the air outlet.

This is additional evidence of the air cleaning

effectiveness of negative ions. The dust can be easily

removed with a clean, dampened cloth or soft brush.

NOTE: it is important to clean the PERMAtech™

filters at recommended intervals. Using the ioniser

in conjunction with dirty filters may result in dirty

particles exiting the air purifier and being attracted

to walls, carpets, furniture and other household

objects. These dirty particles may prove very

difficult to remove.

PRE-OPERATING INSTRUCTIONS

1. After removing the unit from the box, remove

the plastic covering from the unit.

2. Select a firm level place where there are no

obstructions to the air inlet (rear grill) or

filtered air outlet.

3. Remove the inlet grill by pulling the grill

towards you.

4. Remove both PERMAtech™ filters by gripping

on both sides and pulling forward.

5. Remove protective plastic bag from each filter

cartridge. The filter clip can only be attached

to the hang tabs on the filter one way (see

Fig. 2). The filter clip should easily slide onto

the filter hang tabs. Do not use force whilst

attaching the filter clip to the filter. Align the

clip on the PERMAtech™ filter with the rails

on the inside of the unit.(see Fig. 3)

NOTE: The pleated material and rubber gasket

should be facing towards the unit when applied.

6. Replace the inlet grill by sliding back on to the

unit. Make sure that it snaps securely into

position (the grill only goes on one way).

NOTE: Do not point outlet towards wall.

OPERATING INSTRUCTIONS

Your remote control requires (2) AAA batteries

(not included) for operation. Remove batteries

before discarding the remote control. To install

the batteries, simply depress and slide the back

of the remote control with your thumb on the

arrow indentation. Insert batteries according to

the diagram shown inside and replace cover.

• DO NOT mix old and new batteries.

• DO NOT mix alkaline, standard (carbon-zinc)

or rechargeable (nickel-cadmium) batteries.

1. Plug into a suitable electrical outlet.

2. Press the power button ( ) on the control

panel or the remote control. The unit will turn on

high only the first time the unit is turned on. All

other times it is turned on, the unit remembers

the last speed selected and will turn on at that

speed and the power light will illuminate letting

you know the power is on.

3. You can then select the desired speed

setting. This air cleaner has three speed

settings. You can select from HIGH ( ),

MEDIUM( ), or LOW ( ) by pushing the

desired operating speed button on the control

panel or the remote control.

4. To release negative ions into the filtered air,

press the ioniser button ( ) either on the

control panel or the remote control and the

light will illuminate.

5. The ioniser will not work unless the unit is

running.

6. For optimum air filtration, it is recommended to

operate the air purifier continuously. Its rugged

motor is designed to give many years of service.

7. For continuous use it is recommended to operate

the air purifier at the Medium ( ) setting. For

quieter operation or use in a bedroom, select the

Low ( ) setting. When high levels of air pollution

are present, select the HI ( ) setting to quickly

circulate clean filtered air.

8. The air purifier is equipped with oscillation. To

start and stop oscillation of the air cleaner,

push the button identified as Oscillation ( )

on the remote control or control panel.

CLEANING AND MAINTENANCE

1. Turn the air purifier off and unplug it before

cleaning.

2. The outside of the air purifier can be cleaned

with a soft, clean dampened cloth.

3. The rear air inlet grill can be removed and

washed in warm soapy water (not dishwasher

safe). Dry before replacing in the unit.

4. The filtered air outlet can be cleaned of dust

with a small, soft brush.

5. If you wish to clean the inside of the air purifier,

please only use a dry, soft cloth to wipe it down.

PERMATECH

FILTER CLEANING

Filter Indicator Light (E) - Your air purifier has an

indicator light that illuminates when it is time to

clean the PERMAtech™ filters.

1. Every few weeks check the condition of the

pre-filter.

2. Remove the inlet grill. If the foam pre-filter has

collected a noticeable amount of dust, remove it

from the inlet of the grill and wash it in warm soapy

water. Rinse and dry the pre-filter thoroughly

before replacing it in the inlet of the grill.

3. With the inlet grill removed, check the

condition of your PERMAtech™ filters. If the

filters are dirty, remove them by gripping on

both sides and pulling forward.

4. To clean the PERMAtech™ filter use a crevice

tool or brush attachment with your vacuum

cleaner. Run the attachment along the inlet and

outlet side of the filter trying to clean between the

pleated filter layers. (see Fig. 4).

2 3

BAP1500I05M1 v.qxd 2/19/05 10:15 AM Page 7

1 2 3 4 5 6 7 8 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Bionaire BAP1500 Manuel d'utilisateur Page 3

Commentaires sur ces manuels