Bionaire BT18 - 2 Instructions d'exploitation

Naviguer en ligne ou télécharger Instructions d'exploitation pour Ventilateurs des ménages Bionaire BT18 - 2. Bionaire BT18 - 2 Operating instructions Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Holmes Products (Europe) Ltd.
1 Francis Grove
London SW19 4DT
England
Fax: +44 (0)20 8947 8272
Email: enquiriesEurope@jardencs.com
Website address: www.bionaire.com
UK - Free phone Customer Service Helpline 0800 052 3615
P.N.130046
TOWER FAN
BT18
BT19
INSTRUCTION MANUAL
©2008 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and
distributed by Holmes Products (Europe) Ltd., 1 Francis Grove, London SW19 4DT, United Kingdom.
Made in PRC
SPR-112008
q
ualified electrician. If a 13A 3-pin plug is fitted,
i
t must be an ASTA approved plug, conforming
to BS1363 standard. Replacement 3A fuses must
b
e BSI or ASTABS1362 approved.
P
lease note that the colour of these mains wires
may not correspond with the colour markings
t
hat identify the terminals in your plug. Please
proceed as follows:
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
DO NOT CONNECT either of these wires to the
earth terminal in the plug. The earth terminal
plug is marked with the letter "E", or with the
earth symbol , ( ) or coloured GREEN, or
GREEN and YELLOW. Please proceed as follows:
GUARANTEE
PLEASE KEEP YOUR RECEIPT AS THIS
WILL BE REQUIRED FOR ANY CLAIMS
UNDER THIS GUARANTEE.
This appliance is guaranteed for 3 years after
your purchase as described in this document.
During this guarantee period, if in the unlikely
event the appliance no longer functions due to
a design or manufacturing fault, please take it
back to the place of purchase, with your till
receipt and a copy of this guarantee.
The rights and benefits under this guarantee
are additional to your statutory rights, which are
not affected by this guarantee. Only Holmes
Products (Europe) Ltd. (“Holmes”) has the
right to change these terms.
Holmes undertakes within the guarantee period
to repair or replace the appliance, or any part of
appliance found to be not working properly free
of charge provided that:
you promptly notify the place of purchase or
Holmes of the problem; and
the appliance has not been altered in any
way or subjected to damage, misuse, abuse,
repair or alteration by a person other than a
person authorised by Holmes.
Faults that occur through, improper use,
damage, abuse, use with incorrect voltage, acts
of nature, events beyond the control of Holmes,
repair or alteration by a person other than a
person authorised by Holmes or failure to follow
instructions for use are not covered by this
guarantee. Additionally, normal wear and tear,
including, but not limited to, minor discoloration
and scratches are not covered by this
guarantee.
The rights under this guarantee shall only apply
to the original purchaser and shall not extend to
commercial or communal use.
If your appliance includes a country-specific
guarantee or warranty insert please refer to
the terms and conditions of such guarantee or
warranty in place of this guarantee or contact
your local authorized dealer for more
information.
Waste electrical products should not be
disposed of with Household waste. Please
recycle where facilities exist. E-mail us at
[email protected] for further
recycling and WEEE information.
Holmes Products (Europe) Limited
1 Francis Grove
London
SW19 4DT
UK
ASSEMBLY INSTRUCTIONS
(See Fig. 7 & 8)
1. Assemble Base (Q,R) to Fan Housing (P)
making sure the cord is enclosed between
base (Q,R). Secure together with 2 Thumb
screws (S). Refer to Fig.7 for proper
alignment of assembled Base to
Fan Housing.
2. Secure Power Cord (T) to bottom of Base
(Q,R) using the Cord Clamp (V) with 2
crosshead screws (U). Refer to Fig.8.
OPERATING INSTRUCTIONS
(See Fig. 2, 4, 5, 6)
BT18-
To turn on unit (continuos use):
1. Plug in unit
2. Turn timer (B) to I (ON)
3. Select speed setting button I (Low), II (Med),
III (High) (A).
To turn unit OFF:
Select Speed Button (A) (OFF) or turn
Timer (B) to (OFF)
To use Timer Control:
Select a Speed Button (A) I, II or III and turn
Timer (B) to desired time
(up to 120 minutes)
To use Oscillation Control:
Press (C) = Oscillation On, Off
BT19-
Remote Control:
Remote Control requires 2 AAA batteries for
operation. There is a slot on the back of the
unit (Refer to Fig. 6) to store the remote
when not in use.
To turn unit ON (continuos use):
Press (E)- Select a speed I (Low), II
(Med), III (High) shown by the Speed Indicator
lights (D). Ref. to Fig.4.
To turn unit OFF:
Press (E)
To use Timer Control:
Press (K) select desired time for Power to
turn OFF in 1, 2, 4, 8 hours shown by the Timer
Indicator lights (J). Ref. to Fig.4.
To use Oscillation Control:
Press (I) = Oscillation On, Off
To use Breeze/Sleep Modes:
Press (F) Select Natural Breeze or
Sleep Breeze shown by the Indicator lights (G).
• Natural Breeze Mode will randomly
cycle through the fan speed settings from
High, Medium, Low & OFF to simulate a
natural breeze until the user turns the
unit OFF.
• Sleep Breeze Mode will automatically
cycle through the fan speed settings,
starting at High for 3 hours, then Medium
for 2 hours, then on Low until user turns
the unit OFF.
CLEANING AND MAINTENANCE
Always unplug the fan before cleaning
or assembly.
Clean the fan with a soft cloth moistened
with a mild soap solution.
DO NOT allow water to drip on or into the
fan motor housing.
DO NOT open the unit for cleaning.
The manufacturer reserves the right to change
or modify any specifications without notice.
FITTING A REPLACEMENT PLUG FOR
U.K. AND IRELAND ONLY.
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by
a plug of the correct type. For correct type and
correct installation please refer to "Installation
of a plug" below.
INSTALLATION OF A PLUG Applicable to
U.K. and Ireland.
This product is fitted with a 13A plug complying
to BS1363. If this plug is unsuitable or needs to
be replaced, please note the following: The
wires in the mains lead are coloured as such:
BROWN - LIVE
BLUE - NEUTRAL
NOTE: If the terminals in the plug are not
marked or if you are unsure or in doubt about
the installation of the plug please contact a
3 amp
Vue de la page 0
1 2

Résumé du contenu

Page 1 - TOWER FAN

Holmes Products (Europe) Ltd.1 Francis GroveLondon SW19 4DTEnglandFax: +44 (0)20 8947 8272Email: [email protected] address: www.bion

Page 2 - Thumb Screw

BT18Fig. 1ACBFig. 8Fig. 7TUPLEASE READ AND SAVE THESEIMPORTANT INSTRUCTIONSWhen using electrical appliances, basic safetyprecautions should always be

Commentaires sur ces manuels

Pas de commentaire