Bionaire BPH1520 Manuel d'instructions Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
5
Figure 2
1. Display
2. Mode Indicator Lights
3. Mode Button/Adjustment
4. Thermostat Adjustment
FEATURES - OPERATIONS
IMPORTANT:
Before drilling into any wall ensure no electrical
cables are present in the area.
NOTE: Due to the multitude of potential
mounting surfaces, mounting screws are
not included with this product. Please seek
professional assistance or visit your local
hardware store to determine which type of
screw is best for your particular wall.
1. Remove Base (6) from the bottom of the
Base Mount (7). Refer to Figure 3.
2. Remove Base Mount from the bottom of
the Grill (5) by removing the two securing
screws. Refer to Figure 4.
3. Secure the Wall Mounting Bracket (8) to the
wall. Refer to Figure 5.
4. Hang the Heater Unit on the Mounting
Bracket using the hooks located on the
back of the unit.
AUTO SAFETY SHUT-OFF
This heater is equipped with a technologically-
advanced, safety system that automatically
shuts off power to the heater when a potential
overheat temperature is reached. The heater can
only resume operation when you reset it.
NOTE: The Power light will remain lit during
operation.
Reset the Heater
If the unit shuts down:
1. Unplug the heater and wait 30 minutes.
2. Plug in and turn on.
Tip-Over Shut-Off
If the heater is knocked over, it will instantly shut
off. To reset, simply place the heater in an upright
position and turn ON the heater.
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box.
2. Check package for additional parts if unit is not
shipped already assembled.
3. Place the heater on a firm, level surface.
4. Avoid overloading your circuit by not using
other high wattage appliances in the same
outlet. At 1500 Watts, this unit draws 6.8 Amps.
BH1520
4
ENGLISH
PLEASE READ AND SAVE THESE IMPORTANT
INSTRUCTIONS
When using electrical appliances, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock, and injury to
persons, including the following:
1. Read all instructions before using the
appliance.
2. To avoid fire or shock hazard, plug the
appliance into the appropriate outlet.
3. The heater is hot when in use. To avoid
burns, DO NOT let bare skin touch hot
surfaces. If provided, use handles when
moving this heater. Keep combustible
materials, such as furniture, pillows, bedding,
papers, clothes, and curtains at least 0.9 m
(3’) from the front of the heater and keep
them away from the sides and rear.
4. DO NOT run cord under carpeting. DO NOT
cover cord with throw rugs, runners, or the
like. Arrange cord away from traffic area and
where it will not be tripped over.
5. This heater is not intended for use in
bathrooms, laundry areas and similar indoor
locations. NEVER place heater where it may
fall into a bathtub or other water containers.
6. Always unplug the heater when not in use.
7. When unplugging, be sure to pull by the
plug and not the cord.
8. DO NOT insert or allow foreign objects to
enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or
damage the heater.
9. DO NOT operate heater with a damaged
cord or plug, or after the heater
malfunctions, has been dropped or
damaged in any manner. Take appliance to
Authorized Service Center for examination,
electrical or mechanical adjustment, or
repair.
10. A heater has hot and arcing or sparking
parts inside. DO NOT use it in areas where
gasoline, paint, or flammable liquids are
used or stored.
11. Use appliance only for intended household
use as described in this manual. Any other
use not recommended by the manufacturer
may cause fire, electric shock, or injury
to persons. The use of attachments not
recommended or sold by the manufacturer
may cause hazards.
12. DO NOT use outdoors.
13. To prevent a possible fire, DO NOT block
air intakes or exhaust in any manner. DO
NOT use on soft surfaces, like a bed, where
openings may become blocked.
14. To disconnect heater, turn controls to the
OFF position, then remove the plug from
outlet.
15. Avoid the use of an extension cord because
the extension cord may overheat and cause
a risk of fire. However, if you have to use an
extension cord, The electrical rating of the
extension cord must be equal to or greater
than the electrical rating of the heater.
16. DO NOT attempt to repair or adjust any
electrical or mechanical functions on this
unit. Doing so will void your warranty.
The inside of the unit contains no user
serviceable parts. All servicing should be
performed by qualified personnel only.
17. Discontinue use if plug or outlet is hot. It is
recommended that the outlet be replaced if
plug or outlet is hot to touch.
18. If the heater will not operate, see specific
instructions on Auto Safety Shut-off.
19. WARNING: In order to avoid overheating, do
not cover the heater (
).
20. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
21. Close supervision is necessary when any
appliance is used by or near children, or
incapacitated individuals.
CONSUMER SAFETY INFORMATION
THIS APPLIANCE HAS A POLARIZED PLUG (one
blade is wider than the other). To reduce the risk
of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to
install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR
DEFEAT THIS SAFETY FEATURE IN ANY WAY
DESCRIPTIONS (See Figures 1 & 2)
Figure 1
1. Left End Cap
2. Rear Housing
3. Right End Cap
4. Control Panel
5. Grill
6. Base
7. Base Mount
8. Wall Mounting Bracket (not shown)
Figure 1
1. Left End Cap
2. Rear Housing
3. Right End Cap
4. Control Panel
5. Grill
6. Base
7. Base Mount
8. Wall Mounting
Bracket
(not shown)
1
2
4
5
6
7
3
Figure 2
1. Display
2. Mode Indicator Lights
3. Mode Button/Adjustment
4. Thermostat Adjustment
3
2
4
Figure 3 Figure 4
0.5m
0.5m
0.5m
Figure 6Figure 5
6
7
8
5. Grill 6. Base 7. Base Mount 8. Wall Mounting Bracket
1
Vue de la page 1
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire